Karma gets some work done

There are some updates to report. First, we are no longer going to race Whidbey Island, there were a number of issues, crew, time, money, and lack of any top boats entered all made us realize that we would be better off allocating resources somewhere else. The good news is... NO MORE WEIGH INs till Annapolis!! Ahh, the sweet taste of french fries.

In two weeks we have Long Beach Race week where we will race for the Melges 24 Gold Cup. In prep for this regatta we are getting a number of things fixed for this regatta. This is the typical process before any major one design regatta. Make a list of things that caused issues last regatta or that were broken, modify anything the crew thought could be improved, and then give the boat a good cleaning. Our list after San Francisco was fairly small, we needed to solve the spin halyard slipping in anything over 20 knots, replace the backstay, fix the broken spin bag bracket, and we felt that we should probably replace our "pig tail," which literally holds the mast up.

Last Saturday Geoff Davis and I met over at Coronado Mobile Storage to work the spin halyard issue. As is typically the case, as we started to work on replacing the cleat for the spin halyard I noticed that the keel was resting against the front of the keel trunk, which is really bad, but more on that later. We replaced the spin halyard cleat and also pulled the spin halyard, which I dropped off today to get it modified to make it a little thicker in the specific area. I also have the required line for the backstay on order which should arrive tomorrow and I will then fabricate a new backstay to replace the old one. We then pulled off the pig tail and also have another one being fabricated.

Now back to the keel. If you scroll down a bit you will see what Karma looks like on her trailer. Her keel literally lifts into the boat to allow the boat to trailer much more easily as it is not 10 feet high on the trailer (if the keel did not raise). The downside is that the keel can get damaged while towing if the boat is not aligned properly on the trailer. We place foam around the keel to prevent the keel from moving around in the box, but unfortunately during the tow home from SF the foam in the front of the keel slipped out and now there is a nice rub mark on the leading edge of our keel showing the carbon fiber. This is slow, so today the boat was getting fixed and will have a nice shiny leading edge on the keel for Long Beach (provided we don't ding it up on the tow there).

We still need to clean the boat out, it is bone dry down below, but we took on so much salt water in SF that there are salt crystals everywhere. Back to work, and I will try and post some photos later on this week if there is time.

George Roland, out.